1、Introduction

TZ530 is a transparent, extrusion-grade PETG copolyester resin with medium molecular weight and excellent transparency. 

It is specifically designed for the extrusion of high-quality 3D printing filament consumables.

2、Physical & Mechanical Properties

3、Recommended Processing Conditions

4、Drying Process

PETG is highly hygroscopic. Even with low moisture at shipment, pre-drying before filament extrusion is strongly recommended to prevent bubble formation and filament breakage.

5、Hazards & Handling

Copolyester PETG exhibits few toxicity. Under normal‑use conditions, accidental ingestion or skin/eye contact will not result in adverse health effects. 

Nevertheless, caution is advised during the handling, storage, use and disposal of PETG. 

Good housekeeping and dust control are required for safe product handling. Wear heat‑resistant protective gloves in case of direct contact with molten resin.

Vapors and dust may be generated while processing and handling PETG and can irritate the eyes and upper respiratory tract. Use a properly‑approved dust‑respirator.

Adequate general ventilation is recommended for the product processing area.

6、 Waste Disposal

Do not discharge waste material into sewers or groundwater. For unused, uncontaminated PETG, recycling is the preferred option. 

Where recycling is not feasible, send the material to incinerators or other thermal‑treatment facilities. 

The same disposal approach applies to used or contaminated PETG, subject to prior risk assessment. 

All disposal activities shall comply with applicable local laws and regulations.

Note: All physical‑property data and processing guidelines provided are typical reference values only. 

         Suitability for customer‑specific production shall be verified and confirmed by the customer.